HomeLink® System Programming for Genie® garage door openers
Clearing the HomeLink system happens by pressing and holding the first and third buttons down for about 20 seconds or until the indicator on the HomeLink blinks fast. Then release both HomeLink buttons 1 and 3. You only need to clear the HomeLink from your car if you do not have an unused button or this is a pre-owned car that may have a previous owners garage door opener installed.
Programming the car's HomeLink using your Genie garage door opener remote
- Choose the button on your HomeLink that you want to use to open your garage door and have a Genie garage door opener remote that currently operates your garage door nearby.
- Make sure that there are no obstructions, people, or animals in the path of the garage door since it will move during programming.
- While holding the button on your remote also hold down the Homelink button that you wish to have operate your Genie garage door opener.
- The HomeLink light will start flashing slowly, then it will begin to blink fast, when it blinks fast, release both the HomeLink button and the button on your Genie garage door opener remote.
- Find the learn or program (PGRM) button on your Genie garage door opener
- Hold down the learn or program button until the small LED turns on.
- Release the PRGM or Learn button and the larger LED light will begin to blink
- Press the HomeLink button, that you would like to operate your Genie garage door opener 3 times (hold each press for one second). On the fourth press your door should operate.
- This means that your programming of HomeLink to your Genie garage door opener was a success.
If these instructions did not result in a successful pairing of HomeLink to your Genie garage door opener please see links to more detailed instructions per model and HomeLink's page.
Detailed instructions for programming Homelink to a Genie Garage Door Opener (PDF View)
Visit the HomeLink Website for more details
These instructions should work for the following vehicle manufacturers to program Homelink:
- Acura
- Audi
- BMW
- Buick
- Cadillac
- Chevy
- Chrysler
- Dodge
- Fiat
- Ford
- GMC
- Honda
- Hyundai
- Infiniti
- Jeep
- Kia
- Land Rover
- Lexus
- Lincoln
- Mazda
- Mercedes
- Mini
- Mitsubishi
- Nissan
- Porsche
- Ram Truck
- Subaru
- Suzuki
- Tesla
- Toyota
- Volkswagen
- Volvo
34 comments
I tried several times to pair the garage door with my home link and with remote to home link none of the steps in the instructions will allow me to sync to home link. I have two remotes that pairing is successful. I have a Santa Fe 2020 and a STI 2021. I tried several different ways and home link still won’t take it. Both home links did reset to factory. They just won’t learn signal coming from the garage door or remote. Please advice.
Unable to program my 2024 Toyota Grand Highlander despite following all the steps. Looking for suggestions.
@Jae – Please contact our customer service at 1-800-354-3643 for assistance.
I have 2024 Toyota 4Runner. I have tried numerous times to sync up my garage door remote opener and learning code of motor. It is not working when following the steps. Please advise.
@ Julie – It sounds like you may have a unit that can hold up to seven wireless devices. This includes any old remotes, or wireless devices that have been programmed. Once there is seven, any new remote programmed will kick the last one out that was programmed. To fix this, you can clear the receiver. To clear it press and hold the learn code button in until the red led light goes out. Then reprogram each wireless device back in to the power head up to seven.