39027R - EKTC Chain Extension Kit Installation Instructions

Chain Rail Extension Kit 39027R Instructions (Tube Style Chain Rail) 

PDF Printable Instructions for installing the 39027R chain rail extension kit

Preparation: Refer to Assembly/Installation Poster, replace the header section of rail with the extension rail included with this kit.

Add Chain Extension prior to Step 1G. Add extended RED emergency release cord.

39027R Installation Procedure

1) Center idler pulley into EXTENDED header rail slot. Insert clevis pin through header rail hole and idler pulley. Secure with cotter pin. Fig. 1.

2) Insert 5/16”-18 x 2” bolt into EXTENDED header rail and secure with nut.

3) Proceed with the assembly of the rail per Assembly Poster until step 1g.

4) Prior to step 1g, install chain extension.

5) Remove master link from threaded shaft assembly (Gold End) with needle-nose pliers. Fig. 2.

6) Install chain extension with included master link. Fig 3.

7) Reinstall threaded shaft assembly to extended chain with master link removed in step 5. Fig. 3.

8) Continue with the installation poster at step 1g. Fig.4.

9) Discard original RED emergency release cord and install extended RED emergency release cord included with this kit at step 6 on assembly poster.