39057R.S - Circuit Board with Wall Console Installation Instructions

PDF Instructions for replacing the 39057R.S Circuit Board 

39057R.S AC Screw Drive Control Board Replacement

These instructions are written assuming that you will have ample room around Opener to perform this repair. Some rare instances will require removal of the unit from it’s mounting hardware and repair made on a bench or floor. Refer to your Owners Manual for proper assembly and carefully read and understand all warnings and cautions pertaining to your unit.

WARNING
BE SURE ELECTRICAL POWER HAS BEEN DISCONNECTED FROM THE INPUT POWER LINES PRIOR TO REMOVING THE MOTOR COVER.

WARNING
ANY AND ALL REPAIRS MADE TO THIS UNIT MUST BE PERFORMED WITH THE DOOR DISCONNECTED FROM THE OPENER AND IN THE CLOSED POSITION.

1. Pull emergency release cord on the carriage to disengage opener to close the door if necessary. (If unable to lower door using the opener, use extreme caution manually closing the door. Before pulling the emergency release cord, make certain people and objects are clear of the garage door opening.)

2. Unplug the garage door opener power cord from power receptacle.

3. Open the light lens cover by pressing middle tab inward then remove light bulbs. FIG. 1.

4. Remove the wall console and Safe-T-Beam wires from the terminal block located on side of opener FIG. 1. Use a small screwdriver to press in on orange tabs while gently pulling wires from the block. Mark all wires to help when plugging back in. 

5. Unplug all optional accessories installed such as the battery backup and/or networking adapter.

6. Remove the two 5/16” screws securing powerhead cover to chassis. FIG. 2.

7. Allow the motor cover to swing down to access control board and wire harnesses.

8. Remove grounding wires (green) from chassis. FIG. 3.

9. Unplug the below harnesses from the control board. FIG. 4.
• Light socket harness
• Motor harness
• Opto harness
• AC in harness

10. The powerhead cover can now be removed from opener chassis for repair.

11. Remove the control board mounting screws and board.

12.Replacing the control board and opto harness:
•If you are replacing the control board in a unit with a single encoder motor, see FIG. 5A.
•If you are replacing the control board in a unit with a dual encoder motor, see FIG. 5B.
NOTE: Some motors will have a dual encoder bracket but only one encoder, Plug harness as shown in 5A.

Note: Be certain to install all harnesses in the correct position being sure to install with locking tabs facing each other. FIG 4.

13. Mount the control board and secure with the screws removed in step 11.

14. Hang powerhead cover to chassis to install harnesses removed in step 9.

15. Install ground wires onto chassis removed in step 8.

16. Swing the powerhead cover back up onto chassis and secure using the screws removed in step 6.

17. Install wall console and Safe-T-Beam wires. Install battery backup and/or network harnesses if applicable.

18. Install the light bulbs and close the light cover.

19. Plug the garage door opener back in.

20. Reprogram limits, remote controls and accessories, force, and contact reverse settings per owners manual.