G1T Genie One Button Remote Programming Instructions

Genie Garage Door Opener Remote Programming Instructions- For a Genie One Button Remote - G1T-BX

Use these instructions if you are using this 1-Button garage door opener remote as a Genie replacement remote, or adding as an extra garage door opener remote to use with existing ones.  

PDF version

This 1-Button garage door opener remote comes from the factory designed to operate any Genie® Intellicode® type garage door opener.

A. For use with Learn Code Button equipped Openers (1995 to Present) —

1. Remove the battery’s protective film by pulling it out the bottom of the remote.
2. Locate the Learn Code Button and Learn Code Indicator LED on your opener’s powerhead Fig. 1A below (See your owner’s manual).
3. Press and release the Learn Code Button—the Red Learn Code LED will blink rapidly.
4. Press and release the G1T-BX Remote Button, —the Learn Code LED will stay on (stops blinking).
5. Press and release the Remote Button again—the Learn Code LED will turn off.
6. Press and release the Remote Button again—the Door Opener will run.

THE G1T-BX REMOTE IS NOW PROGRAMMED. Repeat as necessary for additional remotes.

B. For use with Program/Set Button equipped Openers (2010 to Present)—

1. Remove the battery’s protective ­film by pulling it out the bottom of the remote.
2. Locate the Program/Set Button and Programming Indicator LEDs on your opener’s powerhead Fig. 1B below (See your owner’s manual).
3. Press the Program/Set button until the round LED will turn blue.
4. Release the Program/Set button—the long LED will blink purple.
5. Press and release the Remote Button, —the long LED will turn steady purple (stops blinking).
6. Press and release the Remote Button again—both LEDs will blink blue and turn off.
7. Press and release the remote button again—the Door Opener will run.

THE REMOTE IS NOW PROGRAMMED. Repeat as necessary for additional remotes.