Safe-T-Beam® Sensor Extender Brackets Installation Instructions

SAFE-T-BEAM® EXTENSION BRACKET KIT (37909S.S) INSTALLATION INSTRUCTIONS 

PARTS INCLUDED:
2 Rail Brackets, 2 Extension Brackets, 2 track bolts, 2 lock nuts, 4 – #10 Mounting screws

REQUIRED TOOLS:
Flat Bladed Screwdriver, Phillips Screwdriver, 7/16" Wrench

ASSEMBLY:
THIS ASSEMBLY REPLACES THE ORIGINAL SAFE-T-BEAM® MOUNTING BRACKET. Figure 1.

1. Remove wires from existing Safe-T-Beam®.

2. Remove Safe-T-Beam®:
a. detach and discard existing bracket (it slides out of Safe-T-Beam®).

3. Attach Rail Brackets to Transmitter and Receiver:
a. the flange of the Rail Bracket should point the same direction as the lens to make mounting easier. Figure 2.

4. Attach Extension Brackets to Rail Brackets:
a. tighten track bolt and lock nut only until snug. Figure 3 and 4.

5. Mount Safe-T-Beam®:
a. adjust brackets equally so that transmitter and receiver are aimed at each other, with a clear line of sight between them and fully tighten track bolt and lock nut.
b. use #10 mounting screws provided. Figure 5. (If desired, reuse existing screws.)

6. Reattach wires.

7. Test Safe-T-Beam® operation in accordance with your garage door operator owners manual.